Team:Calgary/Notebook/Protocols/taqpcr

From 2012.igem.org

Revision as of 01:19, 2 October 2012 by Yqi2011 (Talk | contribs)

Hello! iGEM Calgary's wiki functions best with Javascript enabled, especially for mobile devices. We recommend that you enable Javascript on your device for the best wiki-viewing experience. Thanks!

Taq PCR Protocol

The following is obtained from the Invitrogen Taq PCR kit (although most PCR kits have similar protocols).

Taq PCR Protocol

Reagent Volume ( 1x ) Volume ( 3x ) Volume ( 5x ) Volume ( 15x )
Sterile H2O 36 μL 108 μL 180 μL 540 μL
10X Taq Buffer 5 μL 15 μL 25 μL 75 μL
2mM dNTPs 5 μL 15 μL 25 μL 75 μL
Forward Primer (100 ug/ul) 1 μL 3 μL 5 μL 15 μL
Reverse Primer (100 ug/ul) 1 μL 3 μL 5 μL 15 μL
50mM MgCl2 1.5 μL 4.5 μL 7.5 μL 22.5 μL
Taq Polymerase (50 ug/ul) 0.5 μL 1.5 μL 2.5 μL 7.5 μL

Thermocycler Conditions

  1. 1 Cycle - 6 minutes at 95°C
  2. 36 cycles of:
    1. 1 minute at 95°C
    2. 1 minute at 58°C (this step done at 65°C for higher GC content )
    3. 1 minute at 72°C
  3. 1 Cycle - 10 minutes at 72°C then HOLD at 4°C

Conditions were varied as needed. For example in cases of longer products all 1 minute times were increased to 1.5 or even 3 minutes

Follow the same protocol for a colony PCR.