Team:UTP-Software/SoftwareTool

From 2012.igem.org

(Difference between revisions)
(S2MT Tutorial)
(S2MT Tutorial)
Line 2: Line 2:
== '''S<sup>2</sup>MT Tutorial''' ==
== '''S<sup>2</sup>MT Tutorial''' ==
-
''Writethe tutorial here.''
+
''Write the tutorial here.''
== Next S<sup>2</sup>MT Version ==
== Next S<sup>2</sup>MT Version ==

Revision as of 11:32, 26 September 2012

DSCF7003.jpg
Home Team & Attributions Project S2MT Tutorial Biosinergia Notebook Human Practices Safety Sponsors


UTP-Software NewLogo.PNG


S2MT Tutorial

Write the tutorial here.

Next S2MT Version

Project Details

Steps Followed to design the primers:[1]

  • Both the mutagenic primers must contain the desired mutation and anneal to the same sequence on opposite strands of the plasmid.
  • Primers should be between 25 and 45 bases in length, and the melting temperature (Tm) of the primers should be greater than or equal to 78°C. The following formula is commonly used for estimating the Tm of primers:
  • Tm = 81.5 + 0.41(%GC) − 675 / N  - where N is the primer length in base pairs.
    
  • The desired mutation (deletion or insertion) should be in the middle of the primer with ~10–15 bases of correct sequence on both sides.
  • The primers optimally should have a minimum GC content of 40% and should terminate in one or more C or G bases.
  • Primers need not be 5´ phosphorylated but must be purified either by fast polynucleotide liquid chromatography (FPLC) or by polyacrylamide gel electrophoresis (PAGE). Failure to purify the primers results in a significant decrease in mutation efficiency.
  • It is important to keep primer concentration in excess. Stratagene suggests varying the amount of template while keeping the concentration of the primer constantly in excess.

References

[1]. Stratagene. QuikChange™ Site-Directed Mutagenesis Kit. Catalog #200518. Revision #108005h. Available in: [http://web.physics.ucsb.edu/~deborah/pro/pro_pdf/Stratagene%20QuikChange.pdf].