Team:Evry/ODE model

From 2012.igem.org

(Difference between revisions)
Line 128: Line 128:
</table>
</table>
</center>
</center>
 +
<h2> Sensitivity Analysis</h2>
 +
<p>There are 2 kinds of parameters in this model; those concerning the geometry of the tadpole and those concerning the behaviour of auxin in the tadpole's tissues. As auxin is a plant hormone, we had to evaluate these parameters by taking those of similar molecules.That's why the uncertainties on these measures are very big.For this category, we observed variations from reference value ref*10<sup>-3</sup> to ref*10<sup>3</sup>.
 +
You can see the effect of these variations:
 +
<p>
 +
<ul>
 +
  <li>For permeabilities:
 +
  </li>
 +
  <li>For die rate:
 +
  </li>
 +
</ul>
 +
 +
For the geometrical parameters, we observed variations going from ref*0.3 to ref*2.We've obtained:
 +
<ul>
 +
  <li>For Surfaces:
 +
  </li>
 +
  <li>For Volumes:
 +
  </li>
 +
</ul>
 +
<h2>Results</h2>
<h2>Results</h2>
Line 135: Line 154:
     <p>This first graph is obtained considering no auxin in the tadpole and c<sub>w</sub>=5.10<sup>-3</sup>mol.L<sup>-1</sup> which is the concentration we wanted to use for experiences. The result shows that the quantity of auxin in skin and in the receptor grow until a limit value.  
     <p>This first graph is obtained considering no auxin in the tadpole and c<sub>w</sub>=5.10<sup>-3</sup>mol.L<sup>-1</sup> which is the concentration we wanted to use for experiences. The result shows that the quantity of auxin in skin and in the receptor grow until a limit value.  
     </p>
     </p>
-
     <img src="https://static.igem.org/mediawiki/2012/4/41/Refodegraph.png" width="450px">
+
     <img src="https://static.igem.org/mediawiki/2012/4/41/Refodegraph.png" width="450px" align="left">
   </li>
   </li>
     <li><p>If there has been injected auxin in the receptor and in skin: n<sub>s</sub>(t=0)=10 mmol n<sub>r</sub>(t=0)=10 mmol, we can observe a decrease of auxin in receptor before an establishement of the equilibrium.</p>
     <li><p>If there has been injected auxin in the receptor and in skin: n<sub>s</sub>(t=0)=10 mmol n<sub>r</sub>(t=0)=10 mmol, we can observe a decrease of auxin in receptor before an establishement of the equilibrium.</p>
-
<img src="https://static.igem.org/mediawiki/2012/1/19/Init10inskinandreceptor.png" width="450px">
+
<img src="https://static.igem.org/mediawiki/2012/1/19/Init10inskinandreceptor.png" width="450px" align="left">
   </li>
   </li>
   <li><p> Here , the concentration in water has been devided by ten c<sub>w</sub>=0.5.10<sup>-3</sup>mol.L<sup>-1</sup>, while the initial value of skin is still n<sub>s</sub>(t=0)=10 mmol. We observe first a big increase in the receptor due to the diffusion of the auxin intially injected in skin then a decrease because of the small water concentration in auxin.  
   <li><p> Here , the concentration in water has been devided by ten c<sub>w</sub>=0.5.10<sup>-3</sup>mol.L<sup>-1</sup>, while the initial value of skin is still n<sub>s</sub>(t=0)=10 mmol. We observe first a big increase in the receptor due to the diffusion of the auxin intially injected in skin then a decrease because of the small water concentration in auxin.  
       </p>
       </p>
-
   <img src="https://static.igem.org/mediawiki/2012/4/41/OdegraphInit10Cwater500.png" width="450px">
+
   <img src="https://static.igem.org/mediawiki/2012/4/41/OdegraphInit10Cwater500.png" width="450px" align="left">
   </li>
   </li>

Revision as of 17:44, 26 September 2012

Model using Ordinary Differential Equations(ODE)

Overview

    The first model we developed represents the tadpole as a three compartment system:
    1. The skin that produces (or receives) auxins, denoted S in the equations;
    2. The blood that transport auxins to the organs, denoted B;
    3. The organs (called receptors) that interacts with auxin molecules, denoted R.

    The parallel with (electrical) engineering is made easy: the skin represents a generator that will add a quantity to the system; The blood represents wires, that convey this quantity throughout the system; Finally the organs are the sinks that use the quantity to work.

    This very idealized view of the tadpoles allows to make some interesting simplifications: The processes happening in the system can be approximated using Ordinary Differential Equations (ODE), one of the simplest form of differential equations; Plus, the organs repartition and shape are not taken into account.

    This over-simplication of the problem causes the model to give very imprecise quantitative results but its strength is in allowing us to make some qualitative predictions about the success or failure of some experiments.
    tadpole compartments

    Assumptions

    There are the different assumptions we were constrained to make in order to model the system:
    1. The auxin concentration inside a compartment is homogeneous
    2. This condition is inherent to this kind of modeling.
    3. No auxins can go from the skin directly to the organs.
    4. We have chosen to neglect the exchanges between the skin and the other organs.
    5. The auxin flow follows the concentration gradient between compartments.
    6. This assumption is based on the fact that a small capillary is nothing more than a hole in a cell layer. So the exchanges between the surrounding cells and the capillary are mutual.

    Model description

    Equations

    Each compartment is modeled by a differential equation representing the evolution of the auxin quantity as a function of the time. Each equations are composed of two kinds of terms: creation and degradation. The creation term can represent either a creation of auxin in the compartment or an arriving quantity of auxin from another one. In the same way, the degradation term can either represent a natural degradation of molecules or a quantity leaving the compartment.

    ODE system

    In this system, the J terms represent the fluxes between the different compartments. We made them depend on the concentrations of both the in and out compartments as explained in assumption 2. Their mathematical formulation is the following:

    mathematical expression of fluxes

    Where:
    • S in m2, represents the area of the exchange surface between the two compartments.
    • P in m2, represents the permeability of the membrane between the specified compartments.
    • C in [quantity] / m3, represents the concentration of auxin in the specified compartment

    These flow equations are based on Newton's law of cooling where the difference between the concentrations of the two compartments gives the direction and magnitude of the flow. This allows us to model in a single equations the two opposite flows between the compartments.

    Parameters


    The parameters of the model are hard to estimate because they are an aggregation of different physical values. This is due to the high level view provided by the model. The different parameters are:

    Description Symbol Type Values
    Permeabilities P calculated here
    Contact surfaces S calculated here
    Volumes V calculated here
    Degradation rate Ddie estimated ?
    Creation rate Dborn computed plasmid repartition model

    Sensitivity Analysis

    There are 2 kinds of parameters in this model; those concerning the geometry of the tadpole and those concerning the behaviour of auxin in the tadpole's tissues. As auxin is a plant hormone, we had to evaluate these parameters by taking those of similar molecules.That's why the uncertainties on these measures are very big.For this category, we observed variations from reference value ref*10-3 to ref*103. You can see the effect of these variations:

    • For permeabilities:
    • For die rate:
    For the geometrical parameters, we observed variations going from ref*0.3 to ref*2.We've obtained:
    • For Surfaces:
    • For Volumes:

    Results

    By modifying the initial conditions and cw we have observed globaly 3 different behaviours of the system:
    • This first graph is obtained considering no auxin in the tadpole and cw=5.10-3mol.L-1 which is the concentration we wanted to use for experiences. The result shows that the quantity of auxin in skin and in the receptor grow until a limit value.

    • If there has been injected auxin in the receptor and in skin: ns(t=0)=10 mmol nr(t=0)=10 mmol, we can observe a decrease of auxin in receptor before an establishement of the equilibrium.

    • Here , the concentration in water has been devided by ten cw=0.5.10-3mol.L-1, while the initial value of skin is still ns(t=0)=10 mmol. We observe first a big increase in the receptor due to the diffusion of the auxin intially injected in skin then a decrease because of the small water concentration in auxin.

    • Conclusion

      References

      References:

      Other possible topologies

      With auxin in the external medium:
      tadpole + external compartments

      With a specific receptor organ:
      tadpole + other compartments