Team:TU Darmstadt/Protocols/Miniprep

Miniprep

The miniprep is used to purify plasmids.

Procedures

Fermentas kit

Promega kit

Qiagen kit

MiniPrep steps according to the official Quiagen MiniPrep manual.^[3]

1. Resuspend pelleted bacterial cells in 250 μl Buffer P1 and transfer to a microcentrifuge tube.
   • Ensure that RNase A has been added to Buffer P1. No cell clumps should be visible after resuspension of the pellet.
   • If LyseBlue reagent has been added to Buffer P1, vigorously shake the buffer bottle to ensure LyseBlue particles are completely dissolved. The bacteria should be resuspended completely by vortexing or pipetting up and down until no cell clumps remain.
2. Add 250 μl Buffer P2 and mix thoroughly by inverting the tube 4–6 times.
   • Mix gently by inverting the tube. Do not vortex, as this will result in shearing of genomic DNA.
   • If necessary, continue inverting the tube until the solution becomesviscous and slightly clear. Do not allow the lysis reaction to proceed for more than 5 min.
   • If LyseBlue has been added to Buffer P1 the cell suspension will turn blue after addition of Buffer P2. Mixing should result in a homogeneously colored suspension.
   • If the suspension contains localized colorless regions or if brownish cell clumps are still visible, continue mixing the solution until a homogeneously colored suspension is achieved.
3. Add 350 μl Buffer N3 and mix immediately and thoroughly by inverting the tube 4–6 times.
   • To avoid localized precipitation, mix the solution thoroughly, immediately after addition of Buffer N3. Large culture volumes (e.g. ≥5 ml) may require inverting up to 10 times. The solution should become cloudy.
   • If LyseBlue reagent has been used, the suspension should be mixed until all trace of blue has gone and the suspension is colorless. A homogeneous colorless suspension indicates that the SDS has been effectively precipitated.
4. Centrifuge for 10 min at 13,000 rpm (~17,900 x g) in a table-top microcentrifuge. A compact white pellet will form.
5. Apply the supernatants from step 4 to the QIAprep spin column by decanting or pipetting.
6. Centrifuge for 30–60 s. Discard the flow-through.
7. Recommended: Wash the QIAprep spin column by adding 0.5 ml Buffer PB and centrifuging for 30–60 s. Discard the flow-through.
   • This step is necessary to remove trace nuclease activity when using endA+ strains such as the JM series, HB101 and its derivatives, or any wild-type strain, which have high levels of nuclease activity or high carbohydrate content. #* Host strainssuch as XL-1 Blue and DH5α™ do not require this additional wash step.
8. Wash QIAprep spin column by adding 0.75 ml Buffer PE and centrifuging for 30–60 s.
9. Discard the flow-through, and centrifuge for an additional 1 min to remove residualwash buffer.
   • Important: Residual wash buffer will not be completely removed unless the flow-through is discarded before this additional centrifugation. Residual ethanol from Buffer PE may inhibit subsequent enzymatic reactions.
10. Place the QIAprep column in a clean 1.5 ml microcentrifuge tube. To elute DNA, add 50 μl Buffer EB (10 mM Tris·Cl, pH 8.5) or water to the center of each QIAprep spin column, let stand for 1 min, and centrifuge for 1 min.

References

[3] http://www.qiagen.com/literature/render.aspx?id=370