"
Team:TU Darmstadt/Protocols/Electroporation
From 2012.igem.org
(Difference between revisions)
(→Procedure) |
(→Procedure) |
||
| Line 43: | Line 43: | ||
Electroporation is a [https://2012.igem.org/Team:TU_Darmstadt/Protocols/Bacterial_transformation transformation] method. Genetic material is transfered into competent cells by an electric pulse. | Electroporation is a [https://2012.igem.org/Team:TU_Darmstadt/Protocols/Bacterial_transformation transformation] method. Genetic material is transfered into competent cells by an electric pulse. | ||
=== Procedure === | === Procedure === | ||
| - | # Defrost a stock of [https://2012.igem.org/Team:TU_Darmstadt/Protocols/ | + | # Defrost a stock of [https://2012.igem.org/Team:TU_Darmstadt/Protocols/Electrocompetent_cells competent cells] on ice |
# Mix it with 1 µL of plasmid | # Mix it with 1 µL of plasmid | ||
# Transfer the mixture in an electroporation cuvette | # Transfer the mixture in an electroporation cuvette | ||
Revision as of 16:30, 16 September 2012
Contents |
Electroporation
About
Electroporation is a transformation method. Genetic material is transfered into competent cells by an electric pulse.
Procedure
- Defrost a stock of competent cells on ice
- Mix it with 1 µL of plasmid
- Transfer the mixture in an electroporation cuvette
- Use the following settings for electroporation: 200 Ohm resistance, 2.5 kV current , 2 µF capacity and 2 mm capacitor plate distance
- Pulse
- Add 1 mL of DYT medium to cell suspension directly after the pulse and incubate at 37°C for 1 h
- Finally the cells are ready to be crossed out
Notes
- Important: Use only clean cuvettes for electroporation and wash them very carefully
- Make sure that the cuvettes are perfectly dry to reduce the risk of a shortcut
- Impurities in the plasmid may lead to an arc, if this does occur add small volumes of ddH2O to reduce the conductivity
