Team:Waterloo/Safety

From 2012.igem.org

Revision as of 06:11, 7 September 2012 by Honpeter (Talk | contribs)


This is a template page. READ THESE INSTRUCTIONS.
You are provided with this team page template with which to start the iGEM season. You may choose to personalize it to fit your team but keep the same "look." Or you may choose to take your team wiki to a different level and design your own wiki. You can find some examples HERE.
You MUST have all of the pages listed in the menu below with the names specified. PLEASE keep all of your pages within your teams namespace.


Home Team Official Team Profile Project Parts Submitted to the Registry Modeling Notebook Safety Attributions

SAFETY


Laboratory Safety

The Ribozyme Project is not expected to raise any research, public or environmental safety concerns other than those normally associated with Biosafety Level 2 organisms, such as Escherichia coli (DH5-alpha), which is classified as very low to moderate. The use of this project is primarily reserved for research and laboratory use, therefore, should not purposefully be exposed to the public or environment except after further testing in its specific applications (such as with particular fusion proteins). Furthermore, the basis of our project is to establish a self-excising sequence (ribozymes), which should limit the expression of any intervening sequences to the RNA level. If the intervening sequence were something of environmental or public relevance (such as antibiotic resistance), the experimental design indicates that the sequence will be removed and, thus, not expressed. This is a relevant contribution of the design in limiting expression to the RNA level, which eases environmental hazard concern upon the accidental release of a GMO containing this biobrick. Therefore, the new biobrick parts submitted should not raise any safety issues.


The necessary facility, equipment and handling procedures associated with Level 2 Biosafety concerns were met:

1.Pipetting aids
2.Biosafety cabinets where applicable
3.Laboratory separated from other activities
4.Biohazard sign
5.Proper safety and disposal equipment, including autoclave
6.Personal protective equipment, worn only in the laboratory
7.Screw-capped tubes and bottles
8.Plastic disposable pasteur pipettes, when necessary



All precautions with respect to recombinant DNA were observed:
1.All waste was autoclaved before being thrown away.
2.Researchers practiced aseptic technique and personal hygiene and safety precautions
3.Procedures likely to generate aerosols are performed in a biosafety cabinet
4.Bench surfaces were disinfected with ethanol.
4.Potentially contaminated waste is separated from general waste

Safety Questions


1. Would any of your project ideas raise safety issues in terms of:

  • researcher safety
  • public safety
  • environmental safety?

The self-excising intron project is unlikely to raise safety issues for researchers, public safety or environmental safety. The concerns with regards to safety are the same as any project utilizing recombinant DNA, living bacterial organisms and plasmids with antibiotic resistance.

2. Do any of the new BioBrick parts (or devices) that you made this year raise any safety issues? If yes,

  • did you document these issues in the Registry?
  • how did you manage to handle the safety issue?
  • How could other teams learn from your experience?
This project utilized the same parts from the Waterloo’s 2011 project, and did not raise any a dditional safety issues. While applications of the project would raise safety issues, our proof of concept construction using GFP is relatively safe.

3. Is there a local biosafety group, committee, or review board at your institution? If yes, what does your local biosafety group think about your project?

The laboratories operating at the University of Waterloo have obtained permits from the Bio-Safety Committee in order to perform intended research. Since the Waterloo iGEM team performs all laboratory work in a parent lab under the guidance of the Masters and PhD students of that lab, the projects carried out in the lab are covered by the permits obtained by the parent lab.