Team:EPF-Lausanne/Notebook/2 August 2012

From 2012.igem.org

Revision as of 15:32, 3 August 2012 by Diego.marcos (Talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)



Contents

Gel for the previous day's digestion

150 ml of gel prepared.



Protocol: Gel Electrophoresis


Agarose concentration depends on the size of the DNA to be run. We will mostly use 1%. VOL is the desired volume of gel in ml:


CH Lab

  1. Add 0.01*VOL g of agarose to a clean glass bottle.
  2. Pour VOL/50 ml of 50xTAE in a graduated cylinder. Fill up to VOL ml with di water.
  3. Add the resulting VOL ml of 1xTAE to the glass bottle with agarose.
  4. Microwave, at 7, the bottle (loose cap!) until it boils.
  5. Carefully remove bottle (can be super heated!) and check for the total absence of particles. Microwave again if needed.
  6. Prepare a gel box, with comb, and fill it up with the agarose solution (maybe not the whole solution is needed).
  7. Add 0.05 µl per ml of gel in the box of Red Gel (it's in the iGEM drawer) and stirr until disolved.
  8. Wait until cold and solidified.
  9. Carefully remove comb.
  10. Place the box in the electrophoresis chamber.
  11. Fill up the electrophresis chamber with 1x TAE buffer.
  12. Add blue dye to the DNA samples (6x loading buffer, that is 10 µl in 50 µl of DNA solution).
  13. Inject 30 µl of ladder marker in the first well (that's 1 µg of DNA).
  14. Inject 60 µl of each DNA solution in the other wells.
  15. Set voltage to 70-90 V and run for 30-40 min, or until the dye reaches the last 25% of the gel length (DNA travels from - to +).
  16. Place the gel under the camera, cover, turn UV on and take photos!


Preparing the ladder:

  • get 1kb ladder DNA from the freezer (500 µg/ml).
  • for 30 charges, 30 µl per charge, we need 900 µl:
    • 60 µl of 1kb ladder DNA
    • 150 µl of dye (6x loading buffer)
    • 690 µl of water

BM Lab

In this lab the gels are slightly different. The total volumes for the small, the medium and the large gel are respectively 60ml, 80ml and 90ml. As we use 0.5x TAE buffer instead of 1x, we can use higher voltages (170V seems to work fine). The gel should run 20-40 minutes, not more. As the gel is thinner, load less DNA (up to ~10ul).


Ladder pMP1 pMP2 pMP3 PHY1 PHY2 PHY3 PHY4 pGL1 lig1 pGL2 lig1 pGL3 lig2


Comments

Insert comments about what happened.