Team:EPF-Lausanne/Notebook/6 September 2012

From 2012.igem.org

(Difference between revisions)
(CHO Cells Transfection with Melanopsin and LovTAP)
Line 24: Line 24:
== CHO Cells Transfection with Melanopsin and LovTAP ==
== CHO Cells Transfection with Melanopsin and LovTAP ==
-
{{:Team:EPF-Lausanne/Template/Protocol|CHOTransfection}}
+
{{:Team:EPF-Lausanne/Template/Protocol|TransfectionCHO}}
CHO cells from a seed culture have been transfected. We made two tubes with 100% LovTAP and two tubes with 50% LovTAP and 50% filler DNA. They were later used for a Western blot. These cells were transfected in the morning and were put in the incubator at 11.20. No readout plasmid was used as it was still not ready at the time.
CHO cells from a seed culture have been transfected. We made two tubes with 100% LovTAP and two tubes with 50% LovTAP and 50% filler DNA. They were later used for a Western blot. These cells were transfected in the morning and were put in the incubator at 11.20. No readout plasmid was used as it was still not ready at the time.

Revision as of 16:51, 22 September 2012



Contents

Miniprep of pSB1C3-LovTAP, pSB1C3-RFP and pCEP4-Readout

Minipreps done for yesterday's overnight cultures.




Protocol: Miniprep


The slim tubes can be centrifuged in the machine in front of the "Gel hood", at 4000 rpm for 10 min. The fatter ones, in the E. coli centrifuge by the fridge (the tip can be left inside, since it floats).

Pellets resuspended with RNase containing buffer (Resuspension Buffer R3, from Invitrogen, equivalent to Buffer P1 from Qiagen, in Sowmya's box in the fridge). Note: keep the buffer in ice if you are not bringing it back to the fridge for some minutes.

We then use the QIAGEN QIAprep Spin Miniprep Kit with their [http://www.qiagen.com/literature/render.aspx?id=370 protocol] (page 22) and a microcentrifuge.


DNA Concentration Measurement for the Minipreps

Protocol: DNA Concentration Measurement


  • Take a 6 µl aliquote of the DNA and put back the main DNA tube in the fridge.
  • Go to the room by the E.Coli lab (LBTM, not on Friday morning!) with:
    • The 6 µl aliquote
    • A 10 µl pipet
    • Optionally, the buffer you used for DNA elution (there might be some next to the machine).
  • The machine is the NanoDrop Spectrophotometer.
  • On the computer, click on "Nucleic Acid".
  • Put a 2 µl drop of (nuclease-free) water on the machine's tip as you are asked to and measure.
  • Clean tips (both sides) with a quarter of tissue.
  • Add 2 µl of the buffer you use and click on "Blank".
  • Clean tips (both sides).
  • Add 2 µl of your DNA sample and click "Measure".
  • Clean tips (both sides) with a tissue.
  • Take 2 measurements per sample (for averaging).
  • Print the report when you are done
  • Click on exit.

The important numbers are:

  • 260/280 ratio, must be > 1.8
  • 260/230 ratio, must be > 2 (too big, > 2.5? , might mean too much salts)
  • Of course the DNA concentration.



A Nanodrop measurement of the minipreps was performed. On average, it yielded acceptable concentrations at around 100ng/microliter.


CHO Cells Transfection with Melanopsin and LovTAP

Protocol: Transfection of CHO cells


This is the transfection protocol used at the LBTC lab for CHO DG44 cells. The transfection reagent is PEI ([http://en.wikipedia.org/wiki/Polyethylenimine polyethylenimine]).

Please use the provided Excel sheet to calculate the volume of plasmid you should add to the cells. Replace every value in red by your own, then print the sheet out and follow the provided protocol.


1. Passage seed 1 day prior to transfection.

2. Prepare tubes (yellow caps with holes) by addition of the calculated amount of DNA.

3. Centrifuge the necessary volume of seed (after a PCV measurement), remove conditioned medium with the pump (use a 2 ml serological pipet with a broken neck) and resuspend (first in 10 ml) in necessary volume of fresh medium to achieve the required cell density (3 mio/ml).

4. Add 5 mL of the cell suspension to the tube with DNA and mix orbitally.

5. Add the PEI (45 µl) to the Cell+DNA mixture as soon as possible, flick 3 times.

6. Place in the incubator at 37°C.



CHO cells from a seed culture have been transfected. We made two tubes with 100% LovTAP and two tubes with 50% LovTAP and 50% filler DNA. They were later used for a Western blot. These cells were transfected in the morning and were put in the incubator at 11.20. No readout plasmid was used as it was still not ready at the time. Then we transfected another batch of CHO cells, this time with melanopsin.