Team:UTP-Software/SoftwareTool

From 2012.igem.org

Revision as of 11:24, 26 September 2012 by Egaruz89 (Talk | contribs)
DSCF7003.jpg
Home Team & Attributions Project S2MT Tutorial Biosinergia Notebook Human Practices Safety Sponsors


UTP-Software NewLogo.PNG


S2MT Tutorial

Write here the tutorial.


Next S2MT version

Project Details

Steps Followed to create the primers:

  • Both the mutagenic primers must contain the desired mutation and anneal to the same sequence on opposite strands of the plasmid.
  • Primers should be between 25 and 45 bases in length, and the melting temperature (Tm) of the primers should be greater than or equal to 78°C. The following formula is commonly used for estimating the Tm of primers:
  • Tm = 81.5 + 0.41(%GC) − 675 / N  - where N is the primer length in base pairs.
    
  • The desired mutation (deletion or insertion) should be in the middle of the primer with ~10–15 bases of correct sequence on both sides.
  • The primers optimally should have a minimum GC content of 40% and should terminate in one or more C or G bases.
  • Primers need not be 5´ phosphorylated but must be purified either by fast polynucleotide liquid chromatography (FPLC) or by polyacrylamide gel electrophoresis (PAGE). Failure to purify the primers results in a significant decrease in mutation efficiency.
  • It is important to keep primer concentration in excess. Stratagene suggests varying the amount of template while keeping the concentration of the primer constantly in excess.