Team:Buenos Aires/Results/DevicesTesting

From 2012.igem.org

(Difference between revisions)
(Secretion Rate of Trp as a function of culture growth)
m (Results)
 
(8 intermediate revisions not shown)
Line 218: Line 218:
{|
{|
-
[[File:BsAs2012Odvstimea4.jpg | 150]]
+
[[File:BsAs2012Odvstimea4.jpg | 250px]]
|
|
-
[[File:BsAs2012Odvstimeab.jpg | 150]]
+
[[File:BsAs2012Odvstimeab.jpg | 250px]]
|}
|}
-
Figure X. check
+
Figure1. Cell density vs time for different strains in media that lack tryptophan or in synthetic defined medium (SC).
-
[[File:BsAs2012rate2.jpg| 150]]
+
We can see the cell growth for strain YFP transformed with the tryptophan devices in media that lack tryptophan (-H), compared with the strain transformed with empty plasmid in rich Synthetic Define medium (SC). This last strain grew faster than the others, we again see that our strains needs a longer amount of time to grow.  
-
Figure X. check
+
[[File:BsAs2012rate2.jpg| 450px]]
-
==== Tryptophan secretion at increasing histidine concentrations ====
+
Figure2. Tryptophan export rate for different tryptophan devices or with empty plasmids.
 +
 
 +
We can see that YFP strain transformed with tryptophan export devices hace higher secretion rates, compared with the YFP yeast transformed with empty plasmid that should only diffuse tryptophan through the membrane.
 +
This negative control is about 10% of secretion rate found for the strains with devices and is the same order as the error associated.
 +
 
 +
== Tryptophan secretion at increasing histidine concentrations ==
We asked ourselves which was the dependance of tryptophan secretion on the amount of histidine in medium. We carried on this test in order to determine whether the secretion of tryptophan depends on the concentration of another aminoacid in the media, such as histidine and what would be the necessary amount of histidine in medium for the start of our system.  
We asked ourselves which was the dependance of tryptophan secretion on the amount of histidine in medium. We carried on this test in order to determine whether the secretion of tryptophan depends on the concentration of another aminoacid in the media, such as histidine and what would be the necessary amount of histidine in medium for the start of our system.  
Line 261: Line 266:
===== Results =====
===== Results =====
-
[[File: BsAs2012TrpvHis.jpg|350px]]
+
[[File: BsAs2012TrpvHis1.jpg|350px]]
 +
 
 +
Figure 3. Final tryptophan concentration as a function of histidine concentration in the media.
-
[[File: BsAs2012Trpratio.jpg|350px]]
 
-
[[File: BsAs2012ratioTrpvHisbypromotor.jpg|350px]]
+
With this result we can infer that tryptophan export has no clear dependence on histidine concentration in the media. Therefore, supporting the assumption of the model.
== Measurement of Trp in medium and Basal Production ==
== Measurement of Trp in medium and Basal Production ==

Latest revision as of 04:05, 27 October 2012


Contents

Devices testing

Experimental Setup

Plasmids and BBs

In order to construct the yeast expression plasmids we choosed 3 vectors, 2 with a tryptophan marker and 1 with an histidine marker:

  1. pCM182/5, which are centromeric plasmids with TRP1 marker, and with a doxycycline repressible promoter [Gari et al 1996].
  2. pEG202, with a 2 ori, HIS3 marker and a constitutive promoter (PADH1).


BsAs2012-plasmid-PEG202.jpg 340px

The cloning we did was:

<partinfo>BBa_K792009</partinfo> (PoliHa) <partinfo>BBa_K792010</partinfo> (TRPZipper2) <partinfo>BBa_K792011</partinfo> (PoliHb) <partinfo>BBa_K792012</partinfo> (PoliWb)
pCM182 (TRPa) X X
pCM185 (TRPb) X X
pEG202 (HIS) X X


Cloning protocol

  1. Digestion of plasmids and TRP/HIS export device:
    1. pCM182; pCM 185; BBa_K792010 y BBa_K792012 were digested with BamHI and Pst1 restriction enzymes.
    2. pEG202; BBa_K792009 y BBa_K792011 were digested with BamHI and Not1.
  2. Purification of digested vectors (pCM185; pCM182; pEG202)
  3. Ligation of vectors and devices according the anterior table (T4 ligase protocol, overnight)
  4. Transformation of E. Coli DH5a with the ligation products. Bacterias were plated on LB-agar with Ampicillin, and incubated over night at 37 °C.
  5. Colonies were used for liquid cultures (LB + Ampicillin) and minipreps were made.
  6. Constructions (vector + insert) were checked by digestion with restriction enzymes, and 1%-agarose gel (1kb and 100bp as markers).

Yeast strains

Once obtained the desired constructions, we transformed yeast strains:

  1. TCY3081: W303, bar1-, ura3::PAct1-YFP
  2. TCY3128: W303, bar1-, leu2:: Pprm1-CFP 405


Final transformed strains

We got the following transformed strains:

BsAs2012-icono-Cepa1.jpg Name YFP_TRPa_TRPZipper2
Strain TCY3081 (YFP)
Plasmid pCM182 (TRPa) + <partinfo>BBa_K792010</partinfo> (TRPZipper2)
BsAs2012-icono-Cepa2.jpg Name YFP_TRPa_PoliWb
Strain TCY3081 (YFP)
Plasmid pCM182 (TRPa) + <partinfo>BBa_K792012</partinfo> (PoliWb)
BsAs2012-icono-Cepa3.jpg Name YFP_TRPb_TRPZipper2
Strain TCY3081 (YFP)
Plasmid pCM185 (TRPb) + <partinfo>BBa_K792010</partinfo> (TRPZipper2)
BsAs2012-icono-Cepa4.jpg Name YFP_TRPb_PoliWb
Strain TCY3081 (YFP)
Plasmid pCM185 (TRPb) + <partinfo>BBa_K792012</partinfo> (PoliWb)
BsAs2012-icono-Cepa6.jpg Name CFP_HIS_PoliHa
Strain TCY3128 (CFP)
Plasmid pEG202 (HIS) + <partinfo>BBa_K792009</partinfo> (PoliHa)
BsAs2012-icono-Cepa5.jpg Name CFP_HIS_PoliHb
Strain TCY3128 (CFP)
Plasmid pEG202 (HIS) + <partinfo>BBa_K792011</partinfo> (PoliHb)


Secretion Rate of Trp as a function of culture growth

The first step was to actually check if the construct works: do the transformed yeast strains - with the tryptophan devices- actually secrete tryptophan into the medium?

To test this we used the following strains:

BsAs2012-icono-Cepa3.jpg BsAs2012-icono-Cepa4.jpg BsAs2012-icono-YFP-185.jpg
YFP_TRPb_TRPZipper2 YFP_TRPb_PolyWb YFP_TRPb
BsAs2012-icono-YFP.jpg
YFP
BsAs2012-icono-Cepa1.jpg BsAs2012-icono-Cepa2.jpg BsAs2012-icono-YFP-182.jpg
YFP_TRPa_TRPZipper2 YFP_TRPa_PolyWb YFP_TRPa


Protocol
  • We started 5ml cultures with 3 replica until they reached exponential phase, overnight, using a -T medium.
  • Starting OD for the assay 0.1 (exponential phase).
  • We measured OD every hour until they reached an OD: 0.8 (5 hs approximately).
  • We measured the Trp signal for each culture medium using the spectrofluorometer.

NOTE: The fluorescence meausurements taken for the Tryptophan in the medium, take into account both the aminoacid secreted by the device and the one diffused.

Therefore the secretion rates calculated will be higher than the actual ones. We used an empty plasmid as control to study tryptophan diffusion.

We used a simple model to measure the secretation rate for all the strains. Since the cultures are in exponential phase, we take

BsAs2012-eqTrp1.jpg

After a few calculations, we find that

BsAs2012-eqTrp2.jpg

Results

Next we show the average OD for each strains used, needed to calculate the export rates of Trytophan.

BsAs2012Odvstimea4.jpg

BsAs2012Odvstimeab.jpg

Figure1. Cell density vs time for different strains in media that lack tryptophan or in synthetic defined medium (SC).

We can see the cell growth for strain YFP transformed with the tryptophan devices in media that lack tryptophan (-H), compared with the strain transformed with empty plasmid in rich Synthetic Define medium (SC). This last strain grew faster than the others, we again see that our strains needs a longer amount of time to grow.

BsAs2012rate2.jpg

Figure2. Tryptophan export rate for different tryptophan devices or with empty plasmids.

We can see that YFP strain transformed with tryptophan export devices hace higher secretion rates, compared with the YFP yeast transformed with empty plasmid that should only diffuse tryptophan through the membrane. This negative control is about 10% of secretion rate found for the strains with devices and is the same order as the error associated.

Tryptophan secretion at increasing histidine concentrations

We asked ourselves which was the dependance of tryptophan secretion on the amount of histidine in medium. We carried on this test in order to determine whether the secretion of tryptophan depends on the concentration of another aminoacid in the media, such as histidine and what would be the necessary amount of histidine in medium for the start of our system.

In this experiment we used strains:


BsAs2012-icono-Cepa3.jpg BsAs2012-icono-Cepa4.jpg BsAs2012-icono-YFP-185.jpg
YFP_TRPb_TRPZipper2 YFP_TRPb_PolyWb YFP_TRPb (control)




Protocol
  1. Starters of each strain used were grown over night in -T media, at 30 °C in shaker.
  2. After 12 hs, cells were pelleted and washed with -HT media.
  3. Cultures with increasing concentrations of histidine (0X, 1X, 1/4X and 1/16X) were set at an initial OD: 0.1, for each strain with 2 replica.
  4. We left the cultures in shaker at 30ºC for 5 hours. After that time, we measured the final OD reached by cultures with the use of a spectrophotometer and the amount of tryptophan present in medium with a spectrofluorometer.
Results

BsAs2012TrpvHis1.jpg

Figure 3. Final tryptophan concentration as a function of histidine concentration in the media.


With this result we can infer that tryptophan export has no clear dependence on histidine concentration in the media. Therefore, supporting the assumption of the model.

Measurement of Trp in medium and Basal Production

To check the efectiveness of our biobricks, we must first determine the ammount of tryptophan secreted by natural strains to the medium, so we can compare. With that end in mind, we designed a protocol for measurement of tryptophan in medium, based in its fluorescense at 350nm, when excited with 295nm light. As a previous step, we checked that none of the other aminoacids used in the medium interferes, by graphically comparing the spectres for uncomplemented medium and medium complemented with leucine, uracile and histidine, at an appropiate range.

To determine Trp concentration, we must first have a way to transform our readings (intensity) to a more useful output, so we made a calibration curve, through serialized 1:2 dilutions of our medium, which Trp's concentration is 50mg/mL, until approximately constant intensity.

The procedure to measure secretion rates will be growing the strain from a known OD in exponential growth phase in -T medium and plotting it's OD over time, spin-drying at time=t, retrieving the supernatant's Trp concentration and dividing it by the integral of OD vs. time between time=0 and time=t, so we get to a rate which will be proportional to the number of cells in the culture, which means we can actually compare between different strains. Since our medium is free from Trp, all of it should come from within the cells, and if the culture is growing at exponential rates, lysis should be negligible, so the only explanation would be cells exporting their own Trp.


Trp-bsas2012.png
Graph:Tryptophan calibration curve


Results

As can be seen from the graph the screening of the concentration of the Trp in medium describes an almost lineal function. Through this experiment we can be sure that we would be able to measure increase of Trp in medium as it is exported from the cells, within the biological range of export. The sensitivity of this method seems to be enough to detect concentrations as low as ~0.02mg/mL, and as high as 50mg/mL, maybe more. Since our medium is 50mg/mL, we assume that's the saturation point of the curve. If we get bigger intensities than the one corresponding to it, we will dilute the sample.

Because of time constraints, we haven't been able to check the method with either our designed strains nor the non-exporting ones.