Team:EPF-Lausanne/Notebook/16 August 2012

From 2012.igem.org

Revision as of 12:01, 24 August 2012 by Cactuskid (Talk | contribs)



Contents

Further Checks on LovTap PMP

Protocol: Restriction site digestion


  1. Look for the best pair of restriction sites, ideally with similar digestion temperatures and times.
    1. [http://tools.neb.com/NEBcutter2/ NEBcutter] for finding cutting enzymes.
    2. [http://www.neb.com/nebecomm/DoubleDigestCalculator.asp Double Digest Finder] for the parameters.
  2. Calculate the amounts required of:
    1. DNA
    2. Buffer (usually from 10x to 1x)
    3. BSA, if needed (usually from 100x to 1x)
    4. Enzymes (depends on the amount of DNA)
    5. Water
  3. Get the recommended buffer (and BSA if needed) from the freezer and let defreeze.
  4. Mix all the ingredients, except DNA, in a tube.
  5. Note: Enzymes should stay no longer than a couple of minutes out of the freezer. Don't touch the bottom of the tubes! Don't vortex!
  6. Distribute the mix in as many tubes as DNA samples and add the DNA.
  7. Keep in the Thermomixer at the recommended temperature.

Sowmya's recommended amounts (50 µl total solution):

  • 5 µl of 10x buffer
  • 0.5 µl of 100x BSA
  • 1 µl of each enzyme
  • 5 µl of DNA
  • 37.5 (up to 50 µl) of water.

Protocol based on what was done on July the 4th.



Digestion of l9, l5 w/ EcoRI and HindIII

Digestion of eGFP w/ EcoRI and HindIII

Digestion of eGFP w/ NotI and SpeI


Ligation

Ligation of PGL w/ GFP at a ratio of 1:3 respectively

Ligation of PGL w/ TNFR at a ratio of 1:3

Ligation of cut PGL alone for control

Ligation of PMP w/ LovTap at a ration of 1:3

Ligation of PMP for control

Ligation of PcDNA3.1 + w/ LovTap at a ration of 1:3

Ligation of cut PcDNA3.1 alone for control

Transformation

Protocol: E.Coli Transformation


  1. Thaw the competent E.coli (DH5alpha) cells on ice (not in hands!)
  2. As soon as it is thawed, add 50µl of the cells to the DNA (~50-100 ng of pure plasmid, or some 2 µl usually)
  3. Let it rest on ice for 20-30 min. Meanwhile, put agar plate (with correct antibiotic) at 37°C for prewarming.
  4. Put the tube with DNA+E.coli at 42°C for 45 sec - 1 min (heat shock)
  5. Add 400 µl of LB broth and place at 37°C for 20-30 min (shaking)
  6. Spread the cells on the prewarmed plate (and let it dry)
  7. Incubate the plate upside-down at 37°C for ~14-15 hours (leaving it more than 16h decreases the plasmid quality)


Bacteria were transformed and plated.



Comments

Insert comments about what happened.