Before entering the lab, the assigned Gibson Assembly team for the day organised agar plate requirements, concentration calculations and equipment requirements. All gBlocks had arrived and thus Gibson Assembly was performed on all fragments.
Each tube was labelled with antibiotic (C = Chloramphenicol, K = Kanamycin, A = Ampicillin) resistance contained within the allocated plasmid. Tubes labeled 1 & 2 represent Heme Oxygenase fragment mixtures, tubes labeled 3 represent Deinococcus fragment mixtures & tubes labeled 4 & 5 represent Agrobacterium fragment mixtures. Take note that #1C and #4C contain T7 promoter fragments whereas the other BioBricks are T7 'promoter-less'. Deinococcus BioBrick does not contain any T7 promoters as described here.
Each Gene Block fragment was supplied as 200ng and before use it was dissolved in 20µl of TE buffer. The table below shows each tube with vector & volume, volume of Gibson Master Mix, water volume & volume of each gBlock fragment. After incubation, these were transformed into Top10 cells using the Transformation Protocol found here - Transformation Protocol.
#1C
#2K
#2A
#3K
#3A
#4C
#5K
#5A
1. Addition of 20ng Gene Block Fragments in appropriate tube
2µl Hemo_T7A
2µl Hemo_A
2µl Hemo_A
2µl Deino_A
2µl Deino_A
2µl Agro_T7A
2µl Agro_A
2µl Agro_A
2µl Hemo_B
2µl Hemo_B
2µl Hemo_B
2µl Deino_B
2µl Deino_B
2µl Agro_B
2µl Agro_B
2µl Agro_B
nil
nil
nil
2µl Deino_C
2µl Deino_C
2µl Agro_C
2µl Agro_C
2µl Agro_C
nil
nil
nil
2µl Deino_D
2µl Deino_D
2µl Agro_D
2µl Agro_D
2µl Agro_D
nil
nil
nil
2µl Deino_E
2µl Deino_E
2µl Agro_E
2µl Agro_E
2µl Agro_E
2. Addition of 0.05 pmol of vector
2.7µl PSB-1C3
2.9µl PSB-1K3
2.8µl PSB-1A3
2.9 µl PSB-1K3
2.8 µl PSB-1A3
2.7µl PSB-1C3
2.9µl PSB-1K3
2.8µl PSB-1A3
3. Addition of Gibson Master Mix (µl)
10
10
10
12.9
12.8
12.7
12.9
12.8
4. Addition of deionised H2O
3.3µl
3.1µl
3.2µl
nil
nil
nil
nil
nil
5. After addition of all components incubation at 50°C for 60 min followed.