"

From 2012.igem.org

The modeling portion of the project focuses on three major initiatives:

1. Quantify the initial medium composition which would:

a. Germinate the spores
b. Raise the population to reporter-required levels within the smallest possible spoilage time-frame
c. Maintain an active population at that level for a prolonged period of time, avoiding the onset of dormancy or sporulation

2. The creation of a succinct explanation of TnrA activation, according to current literature.

3. The creation of a dynamic model for B. subtilis suitable for flux balance analysis which responds to environmental cues.

This year, the modeling initiatives focused on providing tangible support for the rest of the team. Theory is all well and good, but a project with such a limited timeframe required focus, it required an engineer. So, who provided what to whom?

Wetwork:

1. provided a series of growth curves for B. subtilis at different starting OD values and glucose amounts across different temperatures
2. Quantified the relationship between the biomass amount and reporter opacity (or would have given enough time)

Modeling:

1. Developed a thermodynamically-constrained FBA model of B. subtilis to fill uptake rates no present in literature
2. Discovered, and verified using experimental data from literature, the coupled nature of potassium uptake and the growth rate
3. Built a spreadsheet for determining the initial amounts of nutrients by combining germination data from MolGen, uptake rates from literature, predicted uptake rates from the FBA model, and analysis of the growth curves from the wetwork team
4. Determined the maximum uptake rate for oxygen (necessary for evaluating the sticker membrane)
5. Pieced together a complete picture of the NH3/NH4-TnrA relationship from literature
6. Proposed a possible ultra-minimal medium predicted by FBA (unfortunately proven false by Renske's testing)
7. In a minor support role, discovered TPX, the polymer used as the outer membrane

Quantification of Initial Medium Composition

Purpose

The B. subtilis within the sticker must go through distinct phases under defined time constraints. The only way to control the amount of biomass, and its behavior, is through the initial medium concentration. The containment unit does not contain any time-release capsules for providing a controlled level of nutrients.

Methods Refresh the page if the presentation does not appear. Alternatively, click here In compliance with the wiki freeze, Google Drive places an unalterable timestamp on the document. Access granted upon request this it requires a specific email address.

Results

A picture is worth a thousand words. Below you will see the spreadsheet which encapsulates all of the relationships and calculations into a user-friendly format. But, what does it mean? Well, lets take a look at the Input section.

1. Temperature The general operating temperature of the device in degrees Celsius
2. OD at the start of log growth This value is modified till the Final OD value is close to the desired value (explained below)
3. Initial amount of potassium Milligrams of potassium at the start

We have the intermediate values either used to calculate the rest, or to simply provide extra information:

1. Number of Spores This is a measure of the number of spores which should be contained in the sticker
2. Generation Time Doubling time in minutes
3. Biomass Production Rate of biomass production in millimolar / grams of dry weight biomass / hour
4. Potassium Uptake Rate of potassium uptake in millimolar / grams of dry weight biomass / hour
5. Length of Exponential Growth Number of hours for which the cells are happily growing exponentially

And, we have the direct values of interest:

6. Final OD This is an experimentally maximized value at which (1) there is enough biomass for the reporter to be visible, and (2) the growth stops because of a lack of potassium not because of cell-crowding (we must ensure volatile transport is not hindered by crowding)
7. Required Glucose Total amount of glucose required to support growth to the final OD, in grams
8. Minimum NH4 Minimum total amount of nitrogen required to support growth to the final OD, in grams

So, what is missing? The endpoints of the active sensing region. When does it start? When does it end? As stated in the slides above, this region starts when there is enough biomass for the reporter to be visible. We know the reporter works, we have seen it. However, the relationship between reporter opacity and amount of biomass has not been quantified.

Also, if you look to the top of this page, this initiative should also adjust the initial amounts to avoid dormancy or sporulation at the final OD. This is quite the sticky wicket. It requires extensive testing for our specific conditions. The best we can find from sporulation studies in literature is that you can expect B. subtilis to start producing spores 5 hours after the end of the exponential growth phase. (References are found in the spreadsheet, available for download upon request)

TnrA Activation

Purpose

Prior to the successful microarray experiment conducted by the wetwork team, the proposed volatile sensing mechanism tied reporter activation to the metabolism of ammonium/ammonia (NH4/NH3+). The nitrogen metabolism in B. subtilis is a convoluted mesh of reactions and (in)activation complexes mostly controlled by the TnrA transcription factor. In order to observe the effect of NH4 uptake on the TnrA, it was necessary to have a concise behavioral diagram. Unfortunately, no such diagram existed. The diagram for nitrogen metabolism on the KEGG database identified most of what was involved, but did so in an unclear manner.

Results

The figure below used the behavioral information from literature to highlight the active and inactive pathways during ammonium uptake. In terms of the project, the creation of this diagram brought to light a critical problem for using TnrA to sense extracellular NH4/NH3+; TnrA is only active when glutamine synthetase (GS) is actively converting NH4 to glutamine. This in turn is regulated by cell growth, not the amount of NH4/NH3+ present. However, in one article it was observed that GS is also active under conditions of nitrogen limitation. If the medium contained the precise amount of glutamine necessary to support the initial growth phase, then the glutamine would be depleted at the sensing phase. GS would activate to try and create more glutamine. GS would only deactivate when the amount of extracellular NH4/NH3+ reached a level to remove the lack of nitrogen as factor limiting further growth.

The real result? If this sensing pathway was selected, then the wetwork team would have to find the necessary levels of glutamine to exploit the edge of nitrogen limitation. Possible, but not exactly the easiest mechanism to implement for the consumer market.



References

1. KEGG Database, "Nitrogen Metabolism - Bacillus subtilis", Kanehisa Laboratories, Last Modified: July 23, 2010. http://www.kegg.jp/kegg-bin/show_pathway?org_name=bsu&mapno=00910
2. SubtiWiki, http://subtiwiki.uni-goettingen.de/wiki/index.php
3. K. Gunka and F. M. Commichau, “Control of glutamate homeostasis in Bacillus subtilis: a complex interplay between ammonium assimilation, glutamate biosynthesis and degradation,” Molecular Microbiology, vol. 85, no. 2, pp. 213–224, 2012.
4. N. Doroshchuk, M. Gelfand, and D. Rodionov, “Regulation of nitrogen metabolism in gram-positive bacteria,” Molecular Biology, vol. 40, no. 5, pp. 829–836, 2006.
5. Study Guide, Chem153C, University of California, Los Angeles.
   http://vohweb.chem.ucla.edu/voh/classes%5Cspring10%5C153CID28%5C11AminoAcidBiosynthesisSQA.pdf

Dynamic Model

Purpose

For our purposes, the dynamic model seeks to provide an explanation for the gene expression observed in the microarray experiment. However, for the scientific community in general, a dynamic model would be enable phenotype prediction over time under varying environmental conditions. Such a model would also be able to predict phenotypes for knock-out mutant strains. Probabilistic integrative modeling (PROM) uses gene expression data across a wide variety of environmental conditions to quantify the link between the transcriptional-regulatory network and the stoichiometric metabolite-reaction matrix. In other words, PROM modulates the reaction fluxes by looking at the likelihood a given reaction is active given the current state of gene expression. This method has been shown to accurately predict growth phenotypes in knock-out strains of E. coli and M. tuberculosis. Unfortunately, PROM does not consider the current environmental cues. It considers a multitude of prior environmental cues through the gene expression data. As such, it is really only useful for predicting fluxes in knock-out strains. Despite this limitation, it is still a great starting point for building a dynamic model as it considers both the transcriptional-regulatory network and a constraint-based stoichiometric model. It does not rely on the sparse kinetic parameters used in ODE models.

Enter integrative dynamic flux balance analysis (idFBA); it combines the signaling, transcriptional-regulatory, and metabolic networks.

Results

The flowchart below shows the progress of the feasibility study. We were able to build a suitable metabolic model, and to find the information necesssary for implementing the transcriptional-regulatory network using PROM. We were even able to obtain some idFBA scripts from an author of the article who happened to be a supervisor to the University of Virginia iGEM team. Unfortunately, the singalling network was a mystery. Sure, Groningen studies this network in B. subtilis quite extensively, but there still are too many gaps to be able to predict the Wetwork team's microarray data from their gas chromatography data.

This initiative did not progress past the feasibility study.



References

1. N. E. Lewis, H. Nagarajan, and B. O. Palsson, “Constraining the metabolic genotype–phenotype relationship using a phylogeny of in silico methods,” Nature Reviews Microbiology, vol. 10, no. 4, pp. 291–305, Apr. 2012.
2. S. Chandrasekaran and N. D. Price, “Probabilistic integrative modeling of genome-scale metabolic and regulatory networks in Escherichia coli and Mycobacterium tuberculosis,” PNAS, vol. 107, no. 41, pp. 17845–17850, Oct. 2010.
3. J. Min Lee, E. P. Gianchandani, J. A. Eddy, and J. A. Papin, “Dynamic Analysis of Integrated Signaling, Metabolic, and Regulatory Networks,” PLoS Comput Biol, vol. 4, no. 5, p. e1000086, May 2008.