The iGEM Team of University of Southern Denmark 2012 igem.sdu.2012@gmail.com

mRNA Isolation	PCR	Miniprep	fun!
Content	Content	Content	Content
Content	Content	Content	Content

Miniprep

Thermo Scientific ® GeneJET Plasmid Miniprep Kit

Growth of Bacterial Cultures: Pick a single colony from a freshly streaked selective plate to inoculate 1-5ml of LB medium supplement with the appropriate selection antibiotic.
Incubate for 12-16 hours at 37°C while shaking at 200-250 rpm. Use a tube or flask with a volume of at least 4 times the culture volume.
Harvest the bacterial culture by centrifugation at 8000 rpm (6800 x g) in a microcentrifuge for 2 min at room temperature. Decant the supernatant and remove all remaining medium.

Purification Protocol: Resuspend the pelleted cells in 250 μl of the Resuspension Solution. Transfer the cell suspension to a microcentrifuge tube. The bacteria should be resuspended completely by vortexing or pipetting up and down until no cell clumps remain.
Add 250 μl of the Lysis Solution and mix thoroughly by inverting the tube 4-6 times until the solution becomes viscous and slightly clear.
Note: Do not vortex to avoid sharing of chromosomal DNA. Do not incubate for more than 5 min to avoid denaturation of supercoiled plasmid DNA.
Add 350 μl of the Neutralization Solution and mix immediately and thoroughly by inverting the tube 4-6 times.
Note: It is important to mix thoroughly and gently after the addition of the Neutralization Solution to avoid localized precipitation of bacterial cell debris.
The neutralized bacterial lysate should become cloudy.
Centrifuge for 5 min to pellet cell debris and chromosomal DNA.
Transfer the supernatant to the supplied GeneJET spin column by decanting or pipetting. Avoid disturbing or transferring the white precipitate.
centrifuge for 1 min. Discard the flow-through and place the column back into the same collection tube.
Note: Do not add bleach to the flow-through.
Add 500 μl of the Wash Solution (diluted with ethanol prior to first use) to the GeneJET spin column.
Centrifuge for 30-60 seconds and discard the flow-through.
Place the column back into the same collection tube.
Repeat the wash procedure (step 7) using 500 μl of the Wash Solution.
Discard the flow-through and centrifuge for an additional 1 min to remove residual Wash Solution. This step is essential to avoid residual ethanol in plasmid preps.
Transfer the GeneJET spin column into a fresh 1.5 ml microcentrifuge tube.
Add 50 μl of the Elution Buffer to the center of GeneJET spin column membrane to elute the plasmid DNA.
Take care not to contact the membrane with the pipette tip. Incubate for 2 min at room temperature and centrifuge for 2 min.
Note: An additional elution step (optional) with ELution Buffer or water will recover residual DNA from the membrane and increase the overall yield by 10-20%.
For elution of plasmids or cosmids > 20kb, prewarm Elution Buffer to 70°C before applying to silica membrane. Discard the column and store the purified plasmid DNA at -20°C.