Team:LMU-Munich/Data/Constitutive

From 2012.igem.org

Revision as of 15:38, 25 September 2012

• Home
• Team
• Project
  • Why Beadzillus?
  • Bacillus Introduction
  • Bacillus BioBrickBox
  • GerminationSTOP
  • Sporobeads
  • Data
  • Applications
• Extras
  • Attributions
  • Collaborations
  • Registry
  • Bacillus Strains
  • Special: Inverter
  • Achievements
• Safety
  • Project Safety
  • Release for application
• Lab Notebook
  • Weekly Journal
  • Protocols
• Human Practice
  • SynBio Day
  • Students Practical Course
  • CAS SynBio Conference
  • Berlin Conference
• Sponsors

Constitutive Bacillus Promoters

Fig. 1: Luminescence measurement of the constitutive Bacillus promoters P_liaG and P_lepA in the reporter vector pSB_Bs3C-luxABCDE. OD₆₀₀ (up), LUMI (middle) and LUMI per OD₆₀₀ (down) depending on the time (h) are shown for two different clones (green/blue). Data derive from three independent experiments, the graphs show the mean fo the three experiments and the standard deviation. Curves were fitted over each other (t=0, OD₆₀₀=0,3) and smoothed by taking the average of three neighboring values.

The constitutive promoters P_liaG and P_lepA were evaluated in the reporter vector pSB_Bs3C-luxABCDE which contains the lux operon . This is why the promoter activity leads to gene expression and to the production of the protein luciferase. The luminescence of this protein can be measured with the plate reader Synergy2 (Biotek) (Fig.1). All clones show a normal growth behaviour. The activity of the promoters increases during transition from log to stationary phase. The second clone of the promoters P_lepA and P_liaG did not show any luminescence activity. Therefore additional clones should be measured. In the beginning of the growth curve the activity of both promoters increases to their maximum. This maximum activity appears during the same growth phase. P_liaG has an activity maximum of about 100.000 Lumi/OD₆₀₀ during the transition from logarithmic to the stationary phase. P_lepA shows a maximum of about 400.000 Lumi/OD₆₀₀. Comparing these two constitutive promoters the activity of P_lepA is about four times higher than the activity of P_liaG. In the late stationary phase the activity completely disappears.

Fig. 2: β-galactosidase assay and growth curve of strains carrying the promoters P_liaG (black) and P_veg (grey) fused to lacZ. β-galactosidase activity (Miller Units)and the growth curve values are the average of two independant clones with their standard deviation that were measured during the same experiment. Experiment shows representative data which was obtained in the same way from three independent experiments.

The two constitutive promoters P_liaG and P_veg were evaluated with the reporter vector pSB_Bs1C-lacZ which contains the lacZ reporter gene (Fig.2). Promoter activity leads to the expression of the β-galactosidase which directly correlates to the promoter activity. The β-galactosidase assay of the constitutive Bacillus promoters P_veg and P_liaG was repeated three times. Data show one representative result. In the beginning of the growth curve both promoters show only low activity. But then it increases to a maximum before it decreases to the begininng level after about seven hours (Data not shown). Summing up the course of activity of both promoters P_veg and P_liaG is very similar based on the growth curve. The highest β-galactosidase activity and therefore the highest activity of the promoter P_veg with a maximum of 65 Miller units can be found during the transition from the logarithmic to the stationary phase. This is about five times higher than the acitivity of the promoter P_liaG with a maximum activity of about 12 Miller Units.