Microsynth

[http://microsynth.ch Microsynth] is a Swiss sequencing company that has a pick-up service at EPFL, which means the sample doesn't need to be sent anywhere. It also has a [http://microsynth.ch/de/10190/Hints-and-Tips.html#stpl library of standard primers], in case there is some kind of common sequence in the vicinity of the sequence of interest that could be used as the starting point for Sanger sequencing.

Requirements

1. Design the sequencing primers that should start approximately 50 bp upstream and downstream of your sequence of interest. If there is a standard sequence in that area, pick a pre-made primer from the [http://microsynth.ch/de/10190/Hints-and-Tips.html#stpl standard list]. You can also order the primers from some other company and send them along with the DNA sample.
2. Test your primers by running a virtual PCR with [http://serialbasics.free.fr/Serial_Cloner.html Serial Cloner] on your sequence. If you get the expected product, they are correct. Log in to the [http://microsynth.ch Microsynth website], place your order and print out the primer barcode.
3. Prepare the DNA of interest according to [http://microsynth.ch/de/10179/Economy-Run.html Microsynth guidelines]. The plasmid concentration should be 80 ng/µl, and the total volume shall be 15 µl. Therefore, you need to take 1.2 µg of DNA from your original sample, and complete it to 15 µl with either pure water, either 10 mM Tris-HCl (pH 8), either 10 mM Tris-HCl (pH 8) with a maximum of 0.01 mM EDTA, depending on your needs. Use the tubes that are recommended by the company.
4. Leave the DNA sample and the primer barcode in the EPFL pick-up area. They will be shipped off to Microsynth.