Catechol Degradation

Catechol is a toxic compound found in tailings ponds that is a by-product of polyaromatic hydrocarbon metabolism (Vaillancourt et al., 2006, Schweigert et al., 2001)). The chemical properties of catechol allow it to react with biomolecules, causing cellular damage including DNA damage, enzyme inactivation and membrane uncoupling (Schweigert et al., 2001).

Catechol is characterized as having a benzene ring with two hydroxyl groups at the 2,3 position. It can be converted to 2-hydroxymuconic acid by the enzyme catechol 2,3-dioxygenase, encoded by the xylE gene on the Tol plasmid of Pseudomonas putida (Nakai et al., 1983).

Currently the registry has two BioBricks available of xylE. One contained xylE with its native ribosome-binding site (BBa_J33204), while the other part contained xylE under the glucose-repressible promoter cstA (BBa_K118021). Given that E. coli is grown in the presence of glucose, we designed a new construct to keep xylE repressed by using the TetR promoter (BBa_R0040).

Fig.1 Genetic circuit for catechol degradation showing XylE biobricked under the TetR promoter

Catechol 2,3-dioxygenase is an extradiol dioxygenase which cleaves catechol adjacent to the two hydroxyl groups. When this occurs 2-hydroxymuconate semialdehyde is produced, which is yellow in colour. This change in colour allows for visual assay to assess the activity of XylE.

Fig.2 Catechol 2,3-dioxygenase (XylE) converts catechol to 2-Hydroxymuconate semialdehyde in the presence of oxygen. Adapted from Shu et al., 1995.

The visual assays were performed with E.coli cells transformed with BBa_K118021 as well as with E.coli cells transformed with the newly constructed part (BBa_K902048) by bringing the supernatant of an overnight culture to a concentration of 0.1 M of catechol. When the part BBa_K118021 was used, the pellet was first washed in M9-MM and centrifuged before catechol was added to the supernatant. This was necessary to avoid the glucose in the LB from repressing the cstA promoter (BBa_K118011). Catechol was added to the supernatant because the reaction takes place outside of the cell. Within minutes of the addition of catechol to the supernatant, the solution turned from the pale yellow of LB to a bright yellow. This assay was completed by following the protocol written by the 2008 Edinburgh iGEM team.

Fig.3 Results of the catechol visual assay using the part K118021. Cultures were grown overnight in LB and the pellets were washed with M9-MM for varying times (From left to right: 0 min, 5 min, 10 min, 15 min, and 20 min.). After this incubation in M9-MM the cells were spun down and catechol was added to the supernatant to bring it to a concentration of 0.1 M. The amount of time didn't affect the colour change in the cultures containing the XylE gene. The right most tube was a culture of E.coli cells without the XylE gene that was used as a control. The controls supernatant remained clear when the catechol was added.

Catechol into hydrocarbons?

After verifying that we could in fact degrade catechol into 2-hydroxymuconate semialdehyde using our xylE construct, we wondered if we could take this any further: perhaps converting it too into hydrocarbons. As catechol is the breakdown product of a number of different degradation pathways, this could be particularly useful. As 2-hydroxymuconate semialdehyde can be further metabolized to pyruvate and acetaldehyde, it seemed possible that these products could then be routed into the fatty acid biosynthesis pathway and converted to alkanes using the Petrobrick once again. Given that the Catechol 2,3-dioxygenase reaction is extracellular, it creates a possible scenario in which cells with the xylE construct could be co-cultured with Petrobrick-containing cells to cooperatively metabolise catechol into hydrocarbons.

In orde to test this, we .... We tried this using both cells expressing the PetroBrick and __ cells with the oleT gene.

Fig.3 Gas chromatograph of catechol degradation assay using the PetroBrick. While there is limited differences between xylE incubated with and without the Petrobrick, there was one peak with a retention time of 10.5 min which was dramatically increased in the co-culture.

Fig.4 Mass spectra of the Petrobrick/xylE co-culture retention peak at 10.5 min from Figure 3. While the identity of this compound is unknown to us presently, it is clear that there is changes occuring to some of the catechol breakdown products.

Fig.5 Gas chromatograph of catechol degradation assay using Micrococcus cadicans a species of bacteria shown to be able to convert fatty acids into alkenes. This identified a similar peak change is in the Petrobrick with a retention time of 10.5 min. This provides additional support for the idea that the Petrobrick and this organism can further degrade catechol breakdown products.

Fig.6 Mass spectra of Micrococcus/xylE co-culture retention peak at 10.5 min from Figure 5. The similarity of this peak to the one found from the PetroBrick co-culture suggests that there may be similar breakdown products for both of these enzymes suggesting that we are capable of modifying catechol further than with xylE alone. We have yet to identify what this compound is.