Denitrogenation

Why focus on nitrogen bioremediation?

The removal of nitrogen heterocycles from the petroleum tailings ponds is important for both of the main goals of the OSCAR project. Since nitrogen containing compounds lower the quality and stability of fuel (Katzer & Sivasubramanian, 1979) , their presence would be detrimental to the usefulness of the hydrocarbons OSCAR could create. The presence of nitrogen compounds in our products also hinders our environmental goals as they have been shown to undergo radical changes, yielding highly genotoxic byproducts (Xu et al). The combination of these two factors makes the removal of nitrogen very important to the success of OSCAR.

Model compounds used to test the ability of our system to remove nitrogen containing compounds.

Our model compounds

Carbazole was chosen as the model compound to study nitrogen containing heterocycles as it accounts for about 70% of nitrogen by mass in petroleum tailings ponds, as well as the fact that it is considered one of the more difficult to degrade (Morales). A pathway that is capable of degrading carbazole could also have the ability to degrade many other types of nitrogen containing compounds found in the tailings ponds. Although the genes in our pathway are mostly designed for carbazole degradation, 3 other compounds have also been chosen to be tested on due to their unique properties. Pyrollidine was chosen because it is a similar, yet less complex heterocycle with nitrogen embedded in the ring. Cyclohexylamine was chosen to test the system's ability to degrade compounds that have the nitrogen as a substituent of a ring. This could allow us to independently test the functionality of genes which perform the 2nd half of carbazole degradation. Finally, 4-PBAH was chosen as it is a complex naphthenic acid that can serve as a model containing two of OSCAR's target compounds (Nitrogen and Carboxylic acid).

Diagram of hydrodenitrogenation (HDN) the most prevalent chemical pathway for removing nitrogen from petroleum. Taken from Columbia University Education Resources.

Why use synthetic biology to accomplish this goal? Why not chemical methods?

The most widely used chemical method for removing nitrogen from fuel sources is called hydrodenitrogenation (HDN). This process is not very efficient, as only 77% of nitrogen containing compounds are actually removed (Zeuthen et al, 2001). It also requires harsh conditions, for example temperatures upwards of 350 deg C and pressures up to 30 Bar. This is mostly because the nitrogen atoms in the ring must be hydrogenated before the carbon-nitrogen bond can be cleaved because this (Katzer & Sivasubramanian). The input of molybdenum based chemical catalysts required for this reaction is also very costly and can produce toxic by-products of its own (Zhu et al, 2008). While these chemical processes are a reasonable method of fuel upregulating they do have major limitations that are difficult to get around from a chemical standpoint. Synthetic biology can potentially offer a new avenue to address these problems, with much more potential for innovation and new ideas.

How are we going to accomplish this?

The goal was to use enzymes produced by the Pseudomonas genus that are responsible for the conversion of carbazole to cathecol with the hope that they will also be able to act on similar nitrogen heterocycles. To make the pathway more efficient we have removed some enzymes from the native pathway that do not directly interact with nitrogen groups, replaced the native promoter with a TetR repressible promoter from the registry with stronger transcription, and explored using alternative enzymes to accomplish some of the critical steps.

The first enzyme in this pathway is carbazole-1,9-dioxygenase (CarA) which is responsible for selectively cleaving the first C-N bond in a nitrogen containing ring structure (Xu et al). This is a 4 part enzyme coded by 3 genes (2xCarAa, CarAc, and CarAd). It converts carbazole into 2'-aminobiphenyl-2,3-diol. (Morales) (Put diagram here)

After this step the nitrogen is broken from the ring, however it is still attached to the structure. From this point, there are two options for the removal of nitrogen from the structure. The first option is the anthranilate 1,2-dioxygenase enzyme, coded by the Ant operon in the native carbazole degradation pathway used by Pseudomonas (Diaz). While this option may seem the most reliable method, it does come with some limitations. It is designed to act on the substrate anthranilate, which is produced in the native pathway by the actions of the CarB and CarC enzymes, however since our synthetic pathway does not include these genes as they do not directly attack nitrogen there is a chance that this enzyme will not interact with our remaining nitrogen group. To this end, we have also biobricked a deaminase enzyme from Rhodococcus erythropolis that has been shown to selectively cleave the 2nd C-N bond from a variety of nitrogen heterocycles (Kilbane)(Kayser). This allows an alternative pathway for the 2nd step of nitrogen removal, possibly making the system more efficient and should show less substrate specificity than the Ant genes allowing us to degrade a wider range of nitrogen containing rings. (get the good diagram of lower pathway options from kilbane paper).

Our constructs

mostly going to be pictures here

What have we shown so far?

graph of LD2 carbazole degradation. make sure to use data with replicates.

Experimental Design

graphical version of slideshow