Team:University College London/LabBook/Week8

From 2012.igem.org

(Difference between revisions)
(7-4)
Line 52: Line 52:
</html>
</html>
-
== Monday 30.7.12 ==
+
== 7-4 ==
-
 
+
-
'''Aim - Picking colonies:''' Colonies were picked for BBa_I750016, which demonstrated colony formation in Expt 7.4 on Friday 27.7.12.
+
-
+
-
<html><div class="protocol protocol-ColPic">Picking Colonies</div><div class="protocolContent"></html>{{:Team:University_College_London/Protocols/ColPic}}<html></div></html>
+
-
 
+
-
'''Step 2 – Inoculating Colonies into a Selective Broth:''' The table below indicates the volume of broth and the concentration of antibiotic required for each BioBrick.
+
-
 
+
-
{| class="wikitable"
+
-
|-
+
-
! colspan="2" |  Samples !! Volume Inoculated !! Broth (ml) !! Antibiotic (ug/ml)
+
-
|-
+
-
| rowspan="8" |BioBrick ||rowspan="2" | BBa_I750016  || 10ul ||rowspan="8" |Lysogeny Broth (5) || rowspan="8" | Ampicillin(50ug/ml)
+
-
|-
+
-
| 90ul
+
-
|}
+
-
 
+
-
 
+
-
== Tuesday 31.7.12 ==
+
-
 
+
-
 
+
-
'''Aim – Results from Colony Picking'''
+
-
 
+
-
'''Results:''' The table below indicates whether there was growth for BBa_I1750016
+
-
 
+
-
 
+
-
{| class="wikitable"
+
-
|-
+
-
! colspan="2" |  Samples !! Volume Inoculated !! Colony Formation
+
-
|-
+
-
| rowspan="8" |BioBrick ||rowspan="2" | BBa_I1750016  || 10μl || Yes
+
-
|-
+
-
| 90μl || Yes
+
-
 
+
-
'''Conclusion:''' We can proceed onto Miniprep, Analytical Digest, and Nanodrop.
+
-
 
+
-
'''Method'''
+
-
 
+
-
'''Miniprep:'''
+
-
<html><div class="protocol protocol-Miniprep">Miniprep Protocol 1 (ANACHEM)</div><div class="protocolContent"></html>{{:Team:University_College_London/Protocols/Miniprep2}}<html></div></html>
+
-
 
+
-
'''Restriction Digest:'''
+
-
<html><div class="protocol protocol-RestrictionEnzymeDigest">Restriction Enzyme Digest Protocol 1</div><div class="protocolContent"></html>{{:Team:University_College_London/Protocols/RestrictionEnzymeDigest1}}<html></div></html>
+
-
 
+
-
'''Step 2 - Setting up Digests and Controls:''' The protocol describes the recipe for (i) Digested Plasmid and (ii) Uncut Control.  The table below indicates that an uncut and an Xba1/Spe1 digested sample be set up for each BioBrick. Set up Eppendorfs as follows
+
-
 
+
-
 
+
-
{| class="wikitable"
+
-
|-
+
-
! colspan="2" |  Samples  !!Recipe !! Enzymes
+
-
|-
+
-
| rowspan="7" |BioBrick || rowspan="2" | BBa_I150016 ||Digested Plasmid || Xba1 & Spe1
+
-
|-
+
-
| Undigested Plasmid (Control) || None
+
-
|}
+
-
 
+
<html>
<html>
</div><div class="experiment"></div>
</div><div class="experiment"></div>
<img id="8-1" src="https://static.igem.org/mediawiki/2012/b/b4/Ucl2012-labbook-graph8-1.png" /><div class="experimentContent">
<img id="8-1" src="https://static.igem.org/mediawiki/2012/b/b4/Ucl2012-labbook-graph8-1.png" /><div class="experimentContent">
</html>
</html>
-
 
== 8-1 ==
== 8-1 ==
<html>
<html>

Revision as of 09:07, 7 August 2012

Contents

Monday 30.6.12

Aim: Repeat the gel from Expt 7.3 (week 7) with a smaller ladder and higher agarose percentage in order to detect the very small inserts of BBa_J23119 (35bp) and BBa_B0034 (12hp). Previous ladder used was 10037 bp, and this time we used a 25bp ladder.

Restriction Enzyme Digest Protocol 1

Step 1 - Thawing cells: Thaw all materials on ice

Step 2 - Adding Ingredient: Add the following ingredients to autoclaved/sterile eppendorf tubes

Component Amount (ul) (one enzyme used) Amount (ul) (two enzymes used)
dH20 2.5 1.5
Buffer 1x 1 1
DNA template 5 5
BSA 0.5 0.5
Enzyme 1 1 2
Enzyme 2 N/A 1


Step 3 - Addition of BioBrick: Flick contents gently and centrifuge.

Step 4 - Centrifuge:

RPM: 14000

Time: 1 minute

Temperature: 18oC

Step 5 - Digest Program: Place the samples on a thermocycler under the following conditions:

RPM: 550

Time: 2.5 hours

Temperature: 37oC

Step 6 - Denaturing Enzymes: If you are not running the samples on a gel immediately, denature the restriction enzymes by running the samples on a thermocycler under the following conditions:

RPM: 550

Time: 25 minutes

Temperature: 65oC


Step 2 - Setting up Digests and Controls: The protocol describes the recipe for (i) Digested Plasmid and (ii) Uncut Control. The table below indicates that an uncut and an Xba1/Spe1 digested sample be set up for each BioBrick. Set up Eppendorfs as follows


Samples Recipe Enzymes
BioBrick BBa_J23119 Digested Plasmid Xba1 & Spe1
Undigested Plasmid (Control) None
BBa_B0034 Digested Plasmid Xba1 & Spe1
Undigested Plasmid (Control) None


Electrophoresis Protocol

Preparing the Gel

Step 1: Within a conical flask, add 3ml 50X TAE, 1.5g Agarose, and 150ml RO water

Step 2: Heat for 1 min in microwave. Swirl. Heat again for 30s. If solution is clear stop. Else repeat.

Step 3: Cool solution under running cold water.

Step 4: Add 20ul ethidium bromide (normal concentration of EB solution is 500ug/ul)

Step 5: Pour into a sealed casting tray in a slow steady stream, ensuring there are no bubbles

Running a gel

Step 6: Add 1 part loading buffer to five parts of loading sample

Step 7: Position the gel in the tank and add TAE buffer, enough to cover the gel by several mm

Step 8: Add 5ul of DNA ladder to lane 1

Step 9: Add samples to the remaining wells

Step 10: Run at 100 volts for 1hour and 15 minutes

Imaging the Gel

Step 11: Place gel in GelDoc 2000 chamber

Step 12: Turn GelDoc 2000 chamber on 

Step 13: From computer: Quantity One > Scanner > Gel_Doc_Xr>Manuqal Acquire

Step 14: Alter the exposure/settings to give a clear image.

TAE - Tris-acetate-EDTA

EDTA - ethylenediamine tetraacetic acid

Results:The image below shows a 3.5% Agarose Gel of an Analytical Restriction Enzyme Digest for Expt 7.3. The high agarose concentration of the gel was intended to slow the progression of DNA fragments to enable us to detect the small inserts of BBa_J23119 and BBa_B0034. The table below indicates the expected sizes of BioBricks and Plasmid Backbones. Accordingly, we used a the smallest available ladder, with fragments ranging from 25bp to 500bp. At the top of the gel it is possible to see the large fragments we detected on a 1000bp gel in Expt 7.3 Week 7. However, we had expected this gel to also demonstrate the BBa_J23119 insert (35bp) corresponding to letter A in Lane 1, and the BBa_B0034 insert, corresponding to letter B in Lane 3. No product was found. As expected, there was no product measurable against the 25bp ladder for the uncut plasmids in Lane 2 and Lane 4.


BioBrick Expected BioBrick Size (bp) Plasmid Backbone Plasmid Expected Size (bp) Combined Size
BBa_J23119 35 PSB1A2 2079 2114
BBa_B0034 12 PSB1A2 2079 2091


Conclusion:No product was detected for either BioBrick insert. However, we do no feel this necessarily proves the transformation failed, especially as we detected the correct plasmid backbone for each in week 7 (Expt 7.3). The modest nanodrop concentration obtained last week suggests that the concentration was not high enough to allow such a small fragment to be visualised. We are considering alternatives such as running a polyacrylamide gel, which is more sensitive to small fragments, or amplifying the fragment using PCR

7-4

8-1

8-2

8-3

8-4

8-5