Team:Grenoble/Modeling/Introduction

From 2012.igem.org

Revision as of 14:54, 26 September 2012 by Clemenni (Talk | contribs)

iGEM Grenoble 2012

Project

Introduction

To model the system, we divided it into two modules:

Signaling module

In this part we used a deterministic model to determine the sensitivity of the sensor. This analysis enabled us to know that the amplification module is required for the incoming signal to drive the subsequent modules.

Internal amplification module

External amplification and communication

We first used deterministic model to evaluate the sensitivity of the amplification loop and determine the response time. A steady state analysis was performed to understand how the system works.

Then, we studied the communication between the bacteria to evaluate the time collective response time of a bacterial population as a whole.

Because we know that the production of protein is not always turned on or turned off, this can lead to false positives/negatives. We could evaluate the false positives, using a stochastic model.